Master Deer Cut-Off Wheels General Purpose – flat/depressed – steel
Abrasive: Aluminum oxide A-Medium-hard, multipurpose tool of hardness T with high cutting performance and long tool life.
Choose the wheel according to your practical application.
Applications: Cutting of sheet metal, profiles and solid material.
Available in a range of sizes and thickness.
Wheel thickness1.1mm/1.5mm/1.8mm/2mm 2.4 mm for multipurpose cutting work
Wheel thicknesses 3.2/3.0 mm for maximum tool life and high lateral stability.
Suitable for use on angle grinders of all output categories.
Best Choice for 3 Advantages:
- Excellent resin bonded agent, safe, good sharpness and strength, especially suitable for high power angle grinder.
- Reinforced mesh discs, tight combination with net and abrasive materials, high properties with cutting and bending strength.
- Suitable for all kinds of metal, ss, steel, alloyed steel
Frequently asked questions and solution for cutting wheel:
Possible Causes | Solution |
The cutting wheel consumption fast | |
The hardness level of wheel is low | Select and adopt the models with high hardness level |
The grinding pressure is too huge | Decrease the grinding pressure |
The inner bores of cutting disc craze | |
The cutting disc gets stuck in the work piece | Move forward and backward evenly, and exert pressure along the diametrical direction |
The cutting disc is used to grinding | Use the grinding disc in grinding process |
The pressure of side direction is too huge | Avoid the flange plate with the same diameter in inner side and outside |
The diameter of inner side and outside is inconsistent | Apply the flange plate with the same diameter in inner side and outside |
The edge crazes while the abrasion wheel is cutting | |
The diameter of the flange plate is too small | Replace the flange plate with large diameter and generally the diameter of flange plate should be required to reach 1/3 of that of the abrasion wheel |
The loading pressure of the flange is so huge that the flange edge of abrasion wheel of deforms | Adjust the pressure of the flange and abrasion wheel to reasonable level |
It is used with improper force while cutting | Decrease the load while cutting and reduce the pressure in side direction |
The diameter of the flange plate is too small | Replace the flange plate with large diameter and generally the diameter of flange plate should be required to reach 1/3 of that of the abrasion wheel |
The fracture of work pieces is burnt severely | |
The hardness level of abrasion wheel is over high | Adopt the abrasion wheel of low hardness level and high efficiency |
The work rate of the equipment is low | Replace it with high work rate |
The belt of the cutting machine is loose | Adjust the tightness of the belt |
The hardness level of abrasion wheel is over high | Adopt the abrasion wheel of low hardness level and high efficiency |
http://www.kaijie-abrasive.com/